The Sinclair Bullet Seating Depth Tool has been used for decades by handloaders seeking the most accuracy out of their rifles. Our newest model is made from one fourth inch ground and polished stainless steel with one end turned down for use with 17 and 20 caliber rifles and the other end used for 22 caliber and up. This tool helps you determine the length of a loaded round touching the rifling. The Sinclair Seating Depth Tool will work with most bolt action, single shot and AR type rifles. The tool includes a Delrin action guide suitable for most bolt-action rifles (0.690” Diameter fits Remingtons, Savages, Winchesters, and many Rugers). For the most accurate measurement, the Sinclair Bullet Seating Depth Tool uses your fireformed brass and bullets so you can expect an exact measurement, every time. Also available are guides use in AR-15's, AR-10's, and Tubb's 2000's. The guide is a little different than our standard bolt-action guides. This guide inserts into the back of the upper receiver (with the bolt removed). The tool is then used as normal. For best results couple this tool with our Bullet Comparators and a good set of calipers to get repeatable and precise Base-To-Ogive measurements.
Präzision für deine Handlader – die Sinclair Bullet Seating Depth Tool!
Das Sinclair Bullet Seating Depth Tool wird seit Jahrzehnten von Handladern verwendet, die die maximale Genauigkeit aus ihren Gewehren herausholen möchten. Unser neuestes Modell besteht aus einem viertel Zoll dickem, geschliffenem und poliertem Edelstahl, mit einem Ende, das für 17 und 20 Kaliber Gewehre gedreht wurde, und dem anderen Ende, das für 22 Kaliber und mehr verwendet wird.
Produktmerkmale:
- Hilft dir, die Länge einer geladenen Patrone, die die Züge berührt, zu bestimmen.
- Funktioniert mit den meisten Repetier-, Einzellader- und AR-Typ-Gewehren.
- Enthält einen Delrin-Aktionsführer, der für die meisten Repetiergewehre geeignet ist (0,690” Durchmesser passt auf Remingtons, Savages, Winchesters und viele Rugers).
- Für die genaueste Messung verwendet das Sinclair Bullet Seating Depth Tool dein feuergeformtes Messing und die Geschosse, sodass du jedes Mal mit einer exakten Messung rechnen kannst.
- Zusätzlich erhältlich sind Führungen für AR-15, AR-10 und Tubb's 2000.
Diese Führung wird etwas anders verwendet als unsere Standard-Repetierführungen. Sie wird in den hinteren Teil des oberen Empfängers eingesetzt (mit entferntem Verschluss). Das Werkzeug wird dann wie gewohnt verwendet. Für die besten Ergebnisse kombiniere dieses Werkzeug mit unseren Bullet Comparators und einem guten Satz Caliper, um wiederholbare und präzise Base-To-Ogive-Messungen zu erhalten.